Table of Contents
Advertisement
CONNECTING WITH OTHER EQUIPMENT
CCTV
CAMERA
SET IN
SENSOR
VERTICAL ADJUSTMENT (Correcting picture vibration at the top and bottom)
The picture vibration can be reduced or eliminated by the following steps.
1 If the vibration occurs in still, slow motion, fast playback (x2) or normal playback in 12H - 960H or 0H mode,
playback a tape which is recorded in 3H mode with this VCR and press the PAUSE button.
If the vibration occurs during normal playback in L12H or L24H mode, playback a tape in each playback mode.
2 Press the VERTICAL ADJUST (+) or (-) button to reduce or eliminate the picture vibration.
N
•
When QUASI V-SYNC is set to "OFF", the picture vibration is not adjustable with the VERTICAL ADJUST buttons.
•
Connection with a CCTV monitor (for surveillance) is recommended.
•
Connecting with some monitors may cause picture vibration and/or picture distortion at the top or bottom of the image
during still or normal playback.
A domestic Television used as a Monitor may be unable to provide a stable picture without vibration and distortion.
MIC
MONITOR TO BE CONNECTED
VIDEO
OUT
VIDEO
IN
SET
RST
REC GND ALM MODE
CLK CALL
IN
OUT
MIC
IN
OUT
AUDIO
IN
OUT
VIDEO
MIC IN
AUDIO
OUT
7
RS-232C
RESET
IN
OUT
S-VIDEO
REMOTE
VIDEO
OUT
VIDEO IN
AUDIO IN
IN
OUT
MONITOR
Advertisement
Table of Contents
