Duplex Reject Offset; Duplex Debow Offset; Duplex Horizontal Infeed Offset; Duplex Vertical Infeed Offset - DataCard CP80 Plus Service Manual

Duplex Reject Offset

The Duplex Reject Offset controls where the duplex flipper stops when in the
reject position.
• Adjust the Duplex Handoff Offset, and then set this value to be 26 units
larger than the Handoff Offset.
Range
Value

Duplex Debow Offset

The Duplex Debow Offset controls where the duplex flipper stops when in the
debow position.
• Adjust the Duplex Handoff Offset, and then set this value to be 42 units
smaller than the Handoff Offset.
Range
Value

Duplex Horizontal Infeed Offset

The Duplex Horizontal Infeed Offset controls how far a card will travel into the
duplex after it leaves the duplex entry sensor. If this value is incorrectly set, the
card may bind as the duplex rotates.
Range
Increase Value
Decrease Value

Duplex Vertical Infeed Offset

The Duplex Vertical Infeed Offset controls how far a card will travel into the
duplex after it leaves the interstage (handoff) sensor. If this value is incorrectly
set, the card may bind as the duplex rotates.
Range
Increase Value
Decrease Value
5-38
1 to 200 (steps)
Duplex Handoff Offset plus 26
1 to 200 (steps)
Duplex Handoff Offset minus 42
1 to 200 (steps)
The card travels further into the duplex.
The card travels less distance into the duplex.
1 to 200 (steps)
The card travels further into the duplex.
The card travels less distance into the duplex.
Adjustments