Lower Platen Roller
Removal Procedure
1.
Turn off the printer and unplug the power cord.
2.
Remove the
(page 6-38).
3.
Remove the
4.
Remove the
5.
Remove the upper platen roller:
A.
B.
Replacement Notes
•
If reusing the roller, clean the rubber with isopropanol and wipe off the original
grease from the shaft.
•
Make sure the washer is between the platen roller and the transport chassis.
•
Put a thin film of Molykote
locations shown.
•
Print several test cards to check print quality.
6-106
Main Enclosure
Upper Foil Drive Assembly
Upper Heater Assembly
Open the retaining flap above the platen roller.
Lift the gear-end of the platen roller, and pull it out the side of the chassis.
®
(page 6-15) and the
(page 6-126).
(page 6-124) from the laminator.
DX grease (Part No. 807421-001) on the shaft at the
Upper Printer Assembly
Removal and Replacement