Lowrance ELITE TI Installation Manual page 33

Data sources - manual source selection
Manual selection is generally only required where there is more
than one source for the same data, and the 'Auto configure'
selected source is not the one desired. Pressing the menu key when
the desired source is highlighted provides additional options:
Configure device
Configure device is available on the ELITE-7Ti only.
Additional device options can be configured from both the Data
source menu or from the Device list. For further information, refer to
"Device list" on page 34.
Scope
Scope is available on the ELITE-7Ti only.
The active data source under any given category, can be set to be
Global or Local.
When a source is set as Global, it will be used by all displays on the
network.
When a source is set as Local, it will only be used by the display that
selected it as the source.
Note:
Ú If changing a display from a Global source to a
different Local source, change the Scope setting to Local
before changing the selected source, otherwise all other
displays will be changed over to the new source.
Note:
Ú Local and Global data settings apply to the selected
data source only. It is not possible to discretely set whether
a data source is Global or Local if it is not the active source
on the display being operated.
Reset Global/Local
Reset Global and Reset Local are available on the ELITE-7Ti only.
Selecting Reset Global runs an Auto data source selection, and
overrides all previous manual source selections made on all
networked devices.
Selecting Reset Local reverts all data source selections on the unit
being used to the Global source settings available from other
networked units.
Software Setup | ELITE Ti Installation Manual
33