Panel Mount - Lowrance ELITE TI Installation Manual

Removing the unit from the quick release bracket
Pull and hold the release handle and then pull the unit from the
bracket.

Panel mount

1.
Check the Mounting Template for scaling accuracy, using a tape
measure or ruler against the ruler printed on the template.
2.
Cut away excess paper, and tape down the template. Check that
it is correctly aligned to a vertical or horizontal reference. Do not
use a bubble level as the vessel might not be level. Adjust
where required.
3.
Drill all marked pilot holes. For recommended pilot hole size,
refer to the Mounting Template.
4.
Using an appropriate saw, cut through the template and
mounting surface, along the dotted line bordering the shaded
center of the template.
5.
Using a fingernail or small flat screwdriver, pry off the corner
clips at the slotted points located at the top or bottom of each
corner clip.
Installation | ELITE Ti Installation Manual
19