Lowrance ELITE TI Installation Manual page 23

1 Avoid mounting within 1 m (3.3') to port (left) of
propeller
2 Conventional clockwise propeller rotation
3 Avoid mounting within 7.5 cm (3") to starboard of
propeller
4 Best mounting location - undisturbed water flow
5 Planing strake - avoid mounting behind here
Note:
Ú Reverse the distance guides (1 & 3) from propeller
where engine is of counterclockwise configuration.
Note:
Ú Vessels with strakes or ribs on the hull can create
large amounts of turbulence at higher speeds. A good
transducer location on these types of boats is between the
ribs closest to the engine.
Note:
Ú If the transducer is not placed in a smooth flow of
water, interference caused by bubbles and turbulence may
show onscreen in the form of random lines or dots. The
unit could also lose bottom signal when the boat is on
plane.
Note:
Ú Trim tabs vary in the amount of turbulence they
create as they are adjusted, stay clear of these.
Mounting the transducer
1 2 3
| ELITE Ti Installation Manual
4 5
23