Initial Access To The Network Camera; Installing Plug-In; Check Network Settings - LevelOne FCS-3000 User Manual

Initial Access to the Network Camera

Installing Plug-in

For the initial access to the LevelOne FCS-3000 Network Camera in Windows, the web
browser may prompt for permission to install a new plug-in for the Network Camera
after a period of time of downloading. Permission request depends on the Internet
security settings of the user's PC or notebook. If the highest security level is set, the
computer may prohibit any installation and execution attempt. This plug-in has been
registered for certificate and is used to display the video in the browser. Users may
click on to proceed. If the web browser does not allow the user to continue to
install, check the Internet security option and lower the security levels or contact
your IT or networking supervisor for help.

Check Network Settings

The Network Camera can be connected either before or immediately after software
installation onto the Local Area Network. The Administrator should complete the
network settings on the configuration page, including the correct subnet mask and IP
address of gateway and DNS. Ask your network administrator or Internet service
provider for the detail information. By default the Network Camera requires the
12