V-Chip Lock Menu - Mitsubishi WS-48613 Owner's Manual

V-Chip Lock Menu: Passcode
V-Chip
Select V-Chip Lock to perform the functions listed below.
V-Chip allows you to Block or Allow programs based upon
rating signals sent by the broadcaster. The TV comes
from the factory with the V-Chip Lock in the Off setting.
You can turn the V-Chip on within the V-Chip Menu or
you can use the V-CHIP button on the remote control to
conveniently turn the V-CHIP on or off.
The factory preset is TV-PG for TV ratings or PG for movie
ratings, allowing only programs rated TV-PG/PG or lower.
You can change the blocking level to various TV ratings
and lettered categories or movie ratings. After changing
channels or devices, there may be up to a 5 second delay
before the V-Chip lock takes effect.
IMPORTANT
If you forget your four-digit Passcode, see
Appendix A.
Entry
Figures 16 and 17
You will see the screen shown in Figure 16 when you press
V-CHIP on the remote control, or the first time you select
the V-Chip Lock menu, or after you have canceled your
passcode. To use the Lock, input a four-digit passcode
with the number buttons on the remote control, then
press ENT(er). You can delete a number and move back
one space by pressing CANCEL. You can exit without
inputting a passcode by pressing MENU or HOME.
After setting a passcode, the V-Chip Lock is active. The
next time you select V-Chip Lock you will see "...enter
your passcode" instead of "...enter a new passcode".
������ ������ ����
�� �� �� ��� ����� ����� � ��� ���������
��� ��� ������ ������� ��� ����� ������
Figure 16. V-Chip Entry screen
64
� � � �
To view a V-Chip blocked program or to watch the
program during a scheduled lock time, you must enter
your 4-digit passcode or change the channel to an
unlocked program. Once you have entered the passcode,
the V-Chip block or Lock by Time will remain released
until the TV is powered Off and then On again.
������� �� �������
������ ������ ��� ������� ������� ��� ������ ��
����� ����
�� ����� ��� �������� ����� ���� ���������
��� ��� ������ ������� ��� ����� ������
Figure 17. V-Chip Passcode screen
V-Chip Start Time and V-Chip Stop
Time
Figure 18
Select the times you would like the V-Chip to be active.
By setting the V-Chip Start Time and V-Chip Stop Time to
the same time, the V-Chip will be active 24 hours a day.
Press ADJUST or to slowly select the time, starting
with the hours. Press and hold ADJUST
quickly select the hours, press ADJUST
minutes.
Figure 18. V-Chip Menu, Start & Stop Time
� � � �
or to
to select the