Mitsubishi WD-60C8 Owner's Manual page 79

Resolving CEC Conflicts, Changing HDMI
Connections, Removing HDMI Devices
Because each manufacturer selects which CEC func-
tions to support, some devices can conflict with other
devices. If control conflicts arise, you can:
• Turn off CEC in the other device's setup menu.
• Turn off TV control of an individual CEC device (see
fiugre 5 below).
• Reset TV control of an individual CEC device (see
figure 6 below).
Turning Off the TV's HDMI Control of an Individual
CEC Device (Figure 5)
1.
MENU on the TV remote control to enter the TV
Press
Main menu.
2.
Select the Inputs menu using the
3.
Select the Inputs > Name menu using the
4.
Highlight the device to remove using the
then the key.
5.
With the device highlighted, select
turn off the TV's ability to control the device.
6.
Press EXIT to clear the menus.
Figure 5. Inputs > Name menu with HDMI Control for
AVR Tuner turned off
Resetting HDMI Control or Removing an HDMI
Device (Figure 6)
1.
Power off the device.
2.
If removing the device, disconnect the HDMI cable.
3.
Press MENU on the TV remote control to enter the TV
Main menu.
4.
Inputs menu using the
Select the
5.
Inputs > Name menu using the
Select the
6.
Highlight the device to reset using the
then the key.
7.
With the device highlighted, select
HDMI Control.
8.
EXIT to clear the menus.
Press
If the device is still connected, the Auto Input
Sensing screen will display.
Figure 6. Inputs > Name menu with AVR DVD deleted.
Using NetCommand HDMI Control
As an example of using NetCommand for HDMI
devices, you would press PLAY on the device itself to:
•
keys.
•
key.
•
key and
Test your equipment with the TV's remote control to
Control Off to
find out which commands are supported. See the table
below for commands that may be available, depending
on the individual device.
CEC-enabled VCR, DVD, and DVR functions that
may be available:
Record/
Playback
*
If you have a CEC-enabled A/V receiver, CEC-enabled
devices connected to the A/V receiver with an HDMI
cable may also be controllable. They can be selected
from the TV's Input Selection menu.
CEC-enabled A/V receiver functions that may be
available:
•
keys.
•
key.
key and
Delete to reset
736 or 835 Series TV. You can use NetCommand IR
"learning" to add commands to those supported by
CEC. You must first connect and place IR emitters for
the devices.
Appendices
Turn on the TV if not already on
Switch to the device (no need to display the
Selection menu)
Begin play of the device
Menu
Navigation
ENTER
Digits 0–9,
—
CANCEL
(to cancel)
The F1 key defaults to work like the device's LIST key.
VOL, MUTE, and menu-navigation keys.
Try the
To open the A/V receiver menu, follow these steps:
1. While watching TV, press
2. Press repeatedly until the Speakers option
displays.
3. Speakers is still displayed, press MENU.
While
Input
Channel Tuning Other
CH / GUIDE
—
F1 (content)
CANCEL
ENTER MENU
AUDIO.
79
*