Mitsubishi WD-60C8 Owner's Manual page 28

28
4. TV Operation and Features
Remote Control, continued
21. MENU: Displays the main TV menu. When a sub-
menu is open, backs up one menu level.
22. EXIT: Closes TV on-screen menus/displays.
23. F1–F4
For devices under NetCommand control:
Perform NetCommand "Learning" to assign your
choice of functions to the F1–F4 keys.
For devices operating independently of
NetCommand: The F1–F4 keys work like the A,
B, C, D buttons on some cable boxes, satellite
receivers, and DVD players. Program the remote
control for your equipment and test the keys. See
Appendix C, "Programming the Remote Control."
25. (PAUSE): Freezes a broadcast TV picture from an
antenna source, cable box, or satellite receiver (if
key has not been reassigned for NetCommand use).
Record/Playback Keys
Use any of these methods to enable the recording and
playback commands of the TV's remote control:
• Program the remote control for your DVR, VCR, or
DVD player/recorder and set the slide switch to VCR,
DVD, CABLE/SAT, or AUDIO as appropriate.
• Check HDMI devices for compatibility with the TV's
NetCommand for HDMI feature (see Appendix E).
• 736 or 835 Series TV: Perform NetCommand IR
"learning" for the device.
24. (RECORD): Records with a VCR or DVR.
25. (PAUSE): Pauses a VCR, DVR, or DVD. See
above for use during TV viewing.
26. (STOP): Stops play of a VCR, DVR, or DVD.
27. (REVERSE): Rewinds a VCR. Reverse scans a
DVR or DVD.
28. (PLAY): Plays a VCR, DVR, or DVD.
29. (FORWARD): Fast forwards a VCR. Forward scans
a DVR or DVD.
Note: To operate other audio/video devices using
the TV's remote control:
• See Appendix C, "Programming the Remote
Control."
• For HDMI devices compatible with the TV's Net-
Command for HDMI feature, see Appendix E.
• 736 or 835 Series TV: See chapter 6, "NetCom-
mand IR Control," for NetCommand IR "Learning"
of device keys.
• For use of specific keys with NetCommand-con-
trolled devices, see "Special Operation Methods,"
page 56.
Resetting the Remote Control
If the slide switch is set to TV and the TV does not
respond properly, reset the remote control.
1.
POWER for several seconds until the
Press and hold
button blinks twice and goes off.
2.
Release the POWER button.
3.
Press keys 0 0 9 3 5 and the POWER button will blink
twice when you finish entering the code. While
entering the code, pause for a moment between
each key press to ensure it is recognized.
Low-Battery Indicator
If you press a key and the POWER key blinks five times,
replace the remote control's batteries.
Care of the Remote Control
• Use only alkaline batteries.
• Be within 20 feet of the equipment.
• Do not press two or more buttons at the same time
unless instructed to do so.
• Do not allow unit to get wet or become heated.
• Avoid dropping on hard surfaces.
• Do not use harsh chemicals to clean. Use only a
soft, lightly moistened cloth.
• Do not mix old and new batteries.