Kodak i4x50 Series Scanner Setup Manual page 33

32
Three sensors cover the width of the paper path. In order for multifed
documents to be detected correctly, they must pass under one of these
sensors.
• Left, Center, Right: this allows you to select which sensor(s) you
want to have turned on. For example, if you know that the left side of
the document has a "sticky" note on it, you can turn off the left sensor.
Length Detection ⎯ when enabled, you can select the maximum
length of the document that can be scanned without a multifeed being
detected. Length detection is used when scanning same-sized
documents to check for overlap. For example, if you are scanning A4
(8.5 x 11-inch) documents in portrait mode, enter a value of 28.57 cm
(11.25 inches) in the Max Length field. The maximum value is 35.56 cm
(13.99 inches).
Action — select what action you want the scanner to take when a
multifeed is detected. With all options, the condition will be logged in
the scanner.
• Stop Scanning: scanning will stop and control will return to the
scanning application (i.e., ends the job). Image(s) of the multifed
document will not be generated. Verify that the paper path has been
cleared and restart the scan session from the scanning application.
• Stop Scanning - generate image(s): scanning will stop and control
will return to the scanning application (i.e., ends the job). Image(s) of
the multifed document will be generated. Verify that the paper path
has been cleared and restart the scan session from the scanning
application.
• Stop Scanning - leave paper in path: scanning will stop
immediately (i.e., making no attempt to clear the paper path) and
control will return to the scanning application (i.e., ends the job).
Image(s) of the multifed document will not be generated. Clear any
documents from the paper path prior to restarting the scan session
from the scanning application.
• Stop Scanning - leave paper at exit: scanning will stop and the last
portion of the multifed document will be held at the transport's exit,
and control will return to the scanning application (i.e., ends the job).
Image(s) of the multifed document will not be generated. Clear any
documents from the paper path prior to restarting the scan session
from the scanning application.
• Continue Scanning: the scanner will continue to scan. Image(s) of
the multifed document will be generated.
• Pause Scanning - generate image(s): scanning will stop but the
scanning application will be waiting for additional images (i.e., stops
the feeder). Image(s) of the multifed document will be generated.
Scanning may be resumed by pressing the Start/Pause button on
the Operator Control Panel. Scanning may be stopped by pressing
the Stop button on the Operator Control Panel or via the scanning
application.
A-61838/ISIS June 2015