Kodak i4x50 Series Scanner Setup Manual page 31

30
Document Handling — allows you to select how the scanner
transports documents through the scanner. This affects how the
documents are fed into the scanner, how fast they move through the
scanner, and how they are placed in the output tray.
• Normal: no additional handling is performed. Best used when all
documents are similar in size.
• Improved Stacking: aids in controlling how the documents are
stacked/ordered in the output tray for mixed document sets. This
should work for the majority of mixed sets.
• Best Stacking: when your document set contains a great variability
in size, this option provides the best control of how the documents
are stacked/ordered within the output tray.
Intelligent Protection — allows you to select how aggressively the
scanner detects documents that enter the scanner incorrectly. This can
occur when documents are not prepared properly for scanning (e.g.,
stapled or paper clipped documents).
• None
• Normal: this is the recommended option as it provides a balance
between minimizing document damage and stopping the scanner
unnecessarily.
• Minimum: select this option if the scanner is stopping too frequently
on documents that you do not want it to detect.
NOTE: Documents may become more damaged before detection
occurs.
• Maximum: select this option to get the least amount of document
damage.
NOTE: This may cause the scanner to stop unnecessarily.
Maximum Length — select a value that indicates the length of the
longest document in your document set.
NOTES:
• Not all combinations of settings are supported at the larger lengths
(e.g., resolution, color, grayscale, etc.). To allow for greater flexibility
with applications, the scanner will not generate an error until it sees a
document whose length is not supported.
• The scanner's throughput may be reduced for larger lengths.
Power Off — allows you to set the amount of time, in minutes, the
scanner has to be in power saver mode before it automatically turns off.
Power Saver — allows you to set the amount of time the scanner (1 to
240 minutes) will remain inactive before the scanner goes into an idle
state. The default is 15 minutes.
A-61838/ISIS June 2015