Bridge Mode - D-Link DAP-1665 User Manual

Section 3 - Configuration
Wireless Mode: Select Bridge from the drop-down menu.
Bridge Band: Select the Bridge Band that you would like to use for the
wireless bridge:
2.4GHz - The bridge can function using 802.11n or 802.11g.
5GHz - The bridge can function using 802.11ac, 802.11n, or
802.11a.
802.11 Mode: Select the 802.11 Mode from the drop-down menu, based on
which 802.11 standard you want the bridge to use.
Wireless Channel: Select the Wireless Channel that you want the bridge to use.
All access points (APs) on the bridge must be using the same
wireless channel.
Channel Width: Select the appropriate Channel Width, either 20MHz or Auto
20/40MHz from the drop-down menu. When you are using the
5GHz band, the Auto 20/40/80MHz option will also be available.
Remote AP MAC: Enter the MAC address for each of the APs in your network that
will serve as bridges in order to wirelessly connect multiple
networks.
Bridge Security:
Select the desired security method from the drop-down menu.
If you select WEP, you should also select the type of characters
to be used for the WEP key, ASCII or Hex, from the drop-down
menu. Then enter the WEP Key in the field provided. If you
select WPA, you should enter a Pre-Shared Key (password) in
the field below. Regardless of the security mode selected, the
settings should be the same on all APs within the bridge. For
further information regarding wireless security, please refer to
"Configuring Wireless Security" on page
Click Save Settings at the top of the page to save the current
configuration.
Note: The Bridge Mode is not completely specified in the Wi-Fi or IEEE standards. This mode will work with other DAP-1665 units. Communication with
other APs (even other D-Link APs) is not guaranteed.
D-Link DAP-1665 User Manual

Bridge Mode

46.
38