Assembly/Dismantling Stone - RIKA Domo Operating Manual

Assembly/Dismantling stone

Note
Only work on the unit when the mains plug has been disconnected and the
stove has cooled completely.
Note
During assembly / dismantling do not allow objects (screws etc.) to fall into
the pellet container – they can block the screw conveyor and damage the
stove.
Note
During any conversion work, take particular care of your fingers and any
panels and stove attachments.
Select soft bases to prevent scratches to your living space furniture and
stove panels.
Open the decorative glass door by pushing the button on the display before you
unplug the stove from the power supply.
To remove the convection fins turn the 4 screws (marked) clockwise, the lid lifts
off. Then carefully remove the convection fins up.
Open the pellet container lid until it stops, in this position, it stays open.
Now remove the two hex screws on the side panel and lift the side wall.
Remove the self-locking hexagon nut including the covering plate which serves
to seal the pellet container, and the hex nut including the washer on the other
side.
Now you can take off the top stone to the front.
For the right front stone remove the self-locking hexagon nut including the
covering plate which serves to seal the pellet container.
Now lift the stone slightly and carefully lift diagonally forward.
#2,5
Install the removed parts in reverse order.
With the green marked screws you can adjust the position of the stones, so that
the decorative glass door and the stones are flush in front. Afterwards you fix
the stones with the self-locking hexagon nuts.
#8
Make sure before mounting the convection fins that the 4 screws (marked in
green) are flush.
#13
Then carefully place the convection fins in the supposed recess and press down
firmly with your hand until the cover locks into place.
# 8
#6
#6
#2,5
|15
14