Adding New Handsets (Optional) - AT&T EP5632/EP5632-2 User Manual

Getting started Getting started

Adding new handsets (optional)

Your telephone system can accommodate up to 12 handsets (AT&T model
EP562, purchased separately). Before using a newly purchased handset, it
must be first registered with the telephone base.
12:00AM
Place in
Charger
12:00AM
Register handset:
Press MENU in the
base. Find 'Register
Handset' in the main
menu. Press SELECT.
12:00AM
Registration
in progress...
NOTE: If you replace
a registered handset,
the new handset will
be assigned the next
available registration
number, rather than the
handset number of the
handset that you are
replacing.
Register Handset
Before registering an additional handset (EP562),
make sure that the handset battery is installed and
charged.
To register a new handset:
1. Place the unregistered handset in the telephone
base or charger.
2. Press the MENU softkey on the telephone base
while in idle mode.
3. Press the UP and DOWN Navkeys to highlight
Register Handset, then press the SELECT
softkey.
• Registering Handset will appear on the
telephone base display.
• Registration in progress... will appear on
the handset display.
• The registration process may take up to 90
seconds to complete.
When the registration process is complete, the
telephone base and handset will generate a
confirmation tone. The newly registered handset will
be assigned the next available handset registration
number. For instance, if you already have two
registered handsets, HANDSET 1 and HANDSET 2,
the next registered handset will be HANDSET 3.
If Registration Failure appears on the handset
display, make sure the telephone base and
handset(s) are in idle mode, then repeat the above
steps. See the Troubleshooting section on page
92 for more information.
If you want your handsets in sequential order, you
must delete all the handset registrations (page
45), then re-register each handset as described in
the above steps.
17
to highlight to highlight