Operating Instructions - Fisher & Paykel DE6060P1 Service Manual

Service Manual
Model No: DE6060P1/DE6060G1/DE5060G1
Install the flexible hose(optional flexible hose)
Connect the narrow end of
connector to the dryer duct pipe
mouth, and then connect the flexible
hose to the wide end of the connector.
Use the clip to fasten connection point
between the flexible hose and
connector (fasten clip with a
screwdriver). Extend the flexible
hose through the duct hole, make sure
the flexible hose is not twisted to allow
the air to be vented outside.
Notes: If duct hole is not available at user's home, make sure the flexible hose
is vented through a window.
The flexible hose should be angled or ensure a vent cap is fitted when vented outside
to avoid water running back into the dryer.
Correct fixing mode:
Fig.1

7.Operating instructions

Attention:
1.Before operation, clean off any dust and dirt inside the drum of the dryer with a damp
towel.
2.Clean off any debris on the lint filter and in the duct to increase the drying efficiency.
Turning on power
Before turning on the power of the dryer, check:
- Whether the supply voltage is in accordance with the value indicated on the name plate.
- The dryer must be grounded securely.
Preparation of laundry load
- Check whether the laundry to be dried is suitable to be placed in the dryer.
- The dryer can only dry laundry which has been spun dry. Do not put in laundry which
is still dripping wet or has excess water.
- Make sure all pockets are empty before placing laundry in the dryer.
- Pull up zippers, mend loosened fasteners and tie up ribbons to prevent the
laundry from being entangled. If necessary, put small items in a laundry bag.
- To achieve a better drying result ensure the clothes are separated before loading into the
dryer.
Flexible connector
Flexible hose
Fig.2 Fig.3
9
Issue
Rev.
Outdoor
Flexible hose clip
Vent cap
Duct hole
diameter 100mm)