Fujitsu Eternus DX60 S2 User Manual page 80

Chapter 7 Troubleshooting
7.1 Check List
■
When the READY LED is not on
If more than ten minutes have passed since the ETERNUS DX Disk storage system's power was
turned on and the READY LED still has not turned on, contact your maintenance engineer.
■
When the FAULT LED is on
Check the general status of ETERNUS Web GUI and perform the necessary action. If none of
these resolve the problem, leave the ETERNUS DX Disk storage system alone and contact your
maintenance engineer.
●
When the general status of ETERNUS Web GUI is
• Check whether one side of the miniSAS cable (for drive enclosures) is connected. If not,
install the connector in the DI port.
• Check if the miniSAS cable (for drive enclosures) is connected. If the miniSAS cable (for drive
enclosures) is not connected, connect it with the following procedure.
●
When the general status of ETERNUS Web GUI is
Check whether the miniSAS cables (for drive enclosures) are connected in the correct order.
If not, reconnect the miniSAS cables in the following order.
ETERNUS DX60 S2 Disk storage system User's Guide -Operation-
When checking the general status and detailed information on products via
ETERNUS CLI, refer to "ETERNUS CLI User's Guide".
Procedure
1
Press the controller enclosure's Power Switch for four seconds or more to turn off the
ETERNUS DX Disk storage system.
Drive enclosures with no miniSAS cables connected will remain on.
2
Connect the miniSAS cable while the drive enclosure is on.
3
Press the controller enclosure's Power Switch to turn on the ETERNUS DX Disk
storage system.
Procedure
1
Press the controller enclosure's Power Switch for four seconds or more to turn off the
ETERNUS DX Disk storage system, and turn off the AC power.
2
Re-connect the miniSAS cable.
3
Make sure that power is being supplied, then turn the ETERNUS DX Disk storage
system on.
Copyright 2011 FUJITSU LIMITED
80
End of procedure
End of procedure
P3AM-5512-02ENZ0