Figure 1.10 3.5" Type Disk; Figure 1.11 Disk Slot Numbers (3.5" Type Controller Enclosure) - Fujitsu Eternus DX60 S2 User Manual

Chapter 1 Components
1.1 Controller Enclosure
●
Part explanation
• LEDs
The states of LEDs are listed below.
Table 1.2
DISK READY
DISK FAULT
●
For 3.5" Disks

Figure 1.10 3.5" type disk

Figure 1.11

Figure 1.11 Disk slot numbers (3.5" type controller enclosure)

ETERNUS DX60 S2 Disk storage system User's Guide -Operation-
Do Not
WARNING
• System disks are installed in Slot#0 and Slot#1. Never remove
system disks. Doing so will render the ETERNUS DX Disk storage
system unusable.
Status and meanings of each LED (2.5" disks)
LED name LED status
(green)
(blinks green)
(orange)
(blinks orange)
DISK READY/FAULT LED
shows the slot number of each disk.
Slot#8 Slot#9
Slot#4 Slot#5
Slot#0 Slot#1
Do Not
WARNING
• System disks are installed in Slot#0 and Slot#1. Never remove
system disks. Doing so will render the ETERNUS DX Disk storage
system unusable.
Copyright 2011 FUJITSU LIMITED
The disk is operating normally.
The disk is in error status.
In response to commands from Microsoft Virtual Disk
Service (VDS), the location of the disk is identified.
Slot#10 Slot#11
Slot#6 Slot#7
Slot#2 Slot#3
15
Disk status
P3AM-5512-02ENZ0