Replacing Anti-Tipper - Invacare Top End Crossfire T6 Owner's Operator And Maintenance Manual

Replacing Anti-tipper

When anti-tippers are used, anti-tippers MUST be adjusted to maintain a 1-1/2 to
2-inch clearance between the bottom of the anti-tipper wheels and the
ground/floor. This spacing should always be checked whenever adjustments/changes
are made to the wheelchair. Failure to maintain proper spacing may result in the
chair tipping over backward causing serious injury or property damage.
1. Press in the release button that secures the existing anti-tipper to the anti-tipper socket
and remove the anti-tipper from the anti-tipper socket.
2. Insert the new anti-tipper into the anti-tipper socket until release button engages.
3. Press in the release button on the anti-tipper bar and install the anti-tipper wheels onto
the new anti-tipper bar.
4. Repeat STEPS 1-3 for the opposite anti-tipper.
5. Measure the distance between the bottom of the anti-tipper wheels and the ground
floor.
6. If necessary, adjust the height of the anti-tippers. Refer to Adjusting Anti-tipper on
page 60.
PART NUMBER
Top Adjustment Hole
Anti-Tipper
Ground/
Floor
Part No 1134872
WARNING
1112178
DETAIL "A" - ANTI-TIPPER
ADJUSTMENT HOLES
Anti-Tipper Bar
Release Buttons
1-1/2 to 2 inch
Clearance
FIGURE 10.1 Adjusting/Replacing Anti-tipper
SECTION 10—ANTI-TIPPER
MEASUREMENT
21 - 1/8-inches
Anti-Tipper
61
Release
Button
Hole
Anti-Tipper Socket
™
Crossfire Series Wheelchairs