Standard Use; Operation, Cold Lamination - GBC HeatSeal H535 Turbo Instruction Manual

GBC5137 HeatSeal H535 Manual EU
Important: Before operating your new laminator, assemble the exit tray to the rear of the machine and lock it in place (fig. 2).

Standard use

Operation, hot lamination
(preset mode)
Connect the laminator power plug to a power outlet.
1
Press the power switch on the back of the laminator to turn on
2
the machine (fig. 3). An audible beep will be heard, the "Preset",
"COLD", and "Ready" symbol will show.
The machine defaults on cold laminating.
3
To select different pouch size and laminating object for hot
4
laminating, check the Laminating Guide for best selection (fig. 1).
5 If the machine is not in the Preset mode, press
choose Preset mode and "Preset" symbol shows (fig. 1).
Under Preset mode, press
6
mode you check from the lamination guide. The 15 modes can
laminate pouches of thickness from 75 micron to 250 micron.
Whatever the thickness, section 1 is for Copy Paper, section 2
is for Brochure Paper and section 3 for Photo Paper. As one of
the 15 Preset laminating modes is selected, the machine begins
warming up. The speed and temperature will adapt
automatically to the mode you selected. Please note that
you can also change the temperature and speed manually (see
next page).
7 As the machine warms up, the hourglass in the top right corner
rotates (fig. 1).
When the machine is ready to laminate, the hourglass disappears,
8
the "Ready" symbol shows up (fig. 1).
9 Insert the document into the pouch. Please note that it has to be
correctly centered into the pouch (fig. 4).
Gently insert the document sealed side of pouch first into
10
laminator (fig. 5).
11 Pouch will exit from the machine into the support tray (fig. 6).
DO NOT LAMINATE AN EMPTY POUCH.

Operation, cold lamination

Turn on the machine: it defaults on the cold laminating mode.
1
The cold function symbol will show to indicate the machine is
ready for cold laminating.
2 If the machine has been previously performed under hot
laminating, use to choose Preset mode and use
adjust the Preset mode to cold function. Wait for the machine to
cool down before the cold laminating symbol shows. Sometimes
the cool down process could last for as long as one hour
depending on the previously set temperature.
20/12/05
button to
or button to select the preset
to
17:15 Page 5
Operation
The following buttons appear on the product:
Reverse
Carrier laminating operation
The major selection menu
Increase a function value
Decrease a function value
The following icons and texts can appear on the display:
Warm-up: The hourglass rotates when the laminator is
warming up. When laminator is ready, the icon disappears.
Ready: to signal that the machine is ready to laminate.
Reverse
Cold laminating
Hot laminating
Preset: 15 preset operation modes
Carrier laminating
1
5