User Interface Module Pc7 Diagnostic Led's; Diagnostic Led's On User Interface Module Pc7 - Miller Electric Auto-Axcess 450 Owner's Manual

7-8. User Interface Module PC7 Diagnostic LED's

2
3
1 User Interface Module PC7
Diagnostic LED's are visible inside unit,
located on PC7 mounted behind the front
panel.
Refer to Section 7-9 for information on
diagnostic LED's.

7-9. Diagnostic LED's On User Interface Module PC7

LED Status
1, 2 On
Off
Reinstall cover after checking diagnostic
LED's.
2 Dip Switch S1
3 Dip Switch S2
See Network Status Table in Section 7-12
See Network Status Table in Section 7-12
Dip switches are used to identify each
circuit board on the internal network. Dip
switch settings are different for each circuit
board. For proper operation, do not change
dip settings from those shown.
Diagnosis
LED1
LED2
1
218 559-A / 803 251-B
OM-210 540 Page 41