Operation - Husky H125BN Operator's Manual

WARNING:
Disconnect the tool from the air supply before clearing a
jammed fastener. Failure to do so could result in serious
personal injury.
CLEARING A JAMMED FASTENER
See Figure 12.
If a nail or fastener becomes jammed in the tool, disconnect
the air hose and keep the tool pointed away from you while
clearing the jam.
 Disconnect the tool from the air supply.
 Insert a flat blade screwdriver under jammed nail. Pry out
nail, use pliers if necessary.
 Remove the bent fastener.
 Use the flat blade screwdriver to push the driver blade to
its top position.
 Reconnect the tool to the air supply.
 Reinstall fasteners and close the magazine.

OPERATION

16
Fig. 1