Husky H125BN Operator's Manual page 11

WARNING:
Always wear eye protection. Eye protection does not fit all
operators in the same way. Make sure the eye protection
chosen has side shields or provides protection from flying
debris both from the front and sides.
PREPARING THE TOOL FOR USE
See Figure 2.
Under normal use conditions, the tool should be lubricated
before connecting the tool to an air supply. Add air tool oil
into the air fitting on the tool once daily with minimal use,
or twice a day with heavy use. Only a few drops of oil at a
time is necessary. Too much oil will only collect inside the
tool and will be noticeable in the exhaust cycle.
Before connecting the tool, check the air compressor gauge
to be sure it is functioning within the proper range of 70-
10 psi.
DUST CAP
See Figure 2.
The dust cap helps prevent dust and debris from entering
the air fitting. Cover the air fitting with the dust cap when
storing the tool.
NO-MAR PAD
See Figure 3 - 4.
The no-mar pad attached to the nose of the tool helps prevent
marring and denting when working with softer woods.
On-board storage for the no-mar pad is located on the
magazine of the tool.
When requesting a replacement pad, request part number
07907004054.
WARNING:
Disconnect the tool from the air supply before removing
or replacing the no-mar pad. Failure to do so could result
in serious personal injury.
The no-mar pad can be removed by pulling it down and away
from the nose. To replace the no-mar pad, fit it into place
over the nose and push up at the back to reseat.
OPERATION
noSE
11
DUST CaP
QUICK-ConnECT
aIR FITTIng
Fig. 
no-maR PaD
Fig. 3
no maR PaD
SToRagE
Fig. 4