5
Lift the old drive out of the drive bay.
6
Set any jumpers on the new drive to match the old drive. See the drive
documentation for further instructions.
7
Insert the new drive, then slide the release lever toward the front of the
case to lock it into place.
8
Reconnect the drive cables using your notes from Step 3. The red-striped
edge on the data ribbon cable indicates Pin 1 and corresponds with Pin 1
on the drive (typically on the side farthest from the power supply
connection). See the drive documentation for more information.
9
Close the case using the instructions in "Closing the case" on page 246.
Upgrading the Gateway Micro Tower Case
www.gateway.com
253