Adding Or Replacing A Hard Drive - Gateway Tower User Manual

9
Slide the new drive into the drive bay until it settles into the indentation,
then slide the release lever toward the front of the case.
10
If you removed a shipping screw, replace the screw.
11
Reconnect the drive cables using your notes from Step 5. The red-striped
edge of the data ribbon cable indicates Pin 1 and corresponds with Pin 1
on the drive (typically on the side farthest from the power supply
connection). See the drive documentation for more information.
12
Insert the left-side bezel tab into the slot on the left side of the computer
case, then swing the right side of the bezel in, towards the case, until the
right-side bezel release tab locks into place.
13
Close the case using the instructions in "Closing the case" on page 246.

Adding or replacing a hard drive

Use these instructions to replace a hard drive.
To replace a hard drive:
1
Identify the computer case style. For more information, see "Identifying
the computer case style" on page 222.
2
Open the case using the instructions in "Opening the case" on page 242.
Upgrading the Gateway Micro Tower Case
www.gateway.com 251