Display/Programming Module / Installation; Am Display Module - Wolf MGK-2-390 Installation Instructions Manual

Either an AM display module or a BM2 programming module must be installed for operating the MGK-2.
AM
Status
Operating mode
Heating mode
Burner status
ON
The AM functions solely as a display module for
the heating appliance. Heating appliance-specific
parameters and values can be programmed and
displayed.
Specification:
• LCD display 3"
• 4 quick start buttons
• 1 rotary selector with push-button function
NB:
• Use when BM2 is used as a remote control or
in a cascade circuit
• AM is always in the heating appliance
32
19. Display / programming module /
installation
ON/OFF switch
BM2
Heating appliance
Heating mode
Burner ON
1x
25.2
Boiler temperature
14:12
The BM2 (programming module) communicates with
the heating appliance and all connected extension
modules via eBUS.
Specification:
• Colour display 3.5", 4 function buttons, 1 rotary
selector with push-button function
• Micro SD card slot for software update
• Central programming unit with weather-
compensated flow temperature control
• Time program for heating, DHW and DHW
circulation
Remove the front panel of the MGK-2 and refit it after
installation of the module.
Insert the AM or BM2 in the slot above the ON/OFF
switch (Wolf logo).
Both modules can be plugged into this slot. Further
commissioning or address assignment measures
specific to the BM2 can be found in the BM2 installation
instructions.
Switch ON power supply / activate MCB and switch ON/
OFF switch to ON on the MGK-2.
1.5
bar
°C
Pressure
20/01/2013
3063772_201507