Using The Magnify Feature - Hitachi CP-X2514WN User Manual

Operating

Using the magnify feature

Press the MAGNIFY ON button on the remote control.
1.
The picture will be magnified, and the MAGNIFY dialog
will appear on the screen. When the MAGNIFY
ON button is pressed for the first time after the
projector is turned on, the picture will be zoomed
by 1.5 times. On the dialog, triangle marks to show
each direction will be displayed.
The display magnification of the projector switches in order with every press
2.
of the MAGNIFY ON button.
For computer signals, HDMI
LAN, USB TYPE A or USB TYPE B port
1.5 times
For video signals, s-video signals, component video signals or
HDMI TM (Component) signals
1.5 times
While the triangles are displayed on the dialog, use the ▲/▼/◄/► cursor
3.
buttons to shift the magnifying area.
Press the MAGNIFY OFF button on the remote control to exit magnification.
4.
● The MAGNIFY dialog will automatically disappear in several seconds with no
operation. The dialog will appear again if the MAGNIFY ON button is pressed
when the dialog has automatically disappeared.
● The magnification is automatically disabled when the displaying signal or its
display condition is changed.
● While the magnification is active, the keystone distortion condition may vary.
It will be restored when the magnification is disabled.
● Some horizontal stripes might be visible on the image while magnification is
active.
● This function is not available in the following cases:
- A sync signal in the range not supported is input.
- There is no input signal.
26
TM
2 times 3 times
2 times 1 time
(RGB) signals, input signals from the
4 times 1 time
MAGNIFY
ON/OFF button
VIDEO COMPUTER MY SOURCE/
DOC.CAMERA
ASPECT AUTO SEARCH BLANK
MAGNIFY FREEZE PAGE VOLUME
UP
ON
OFF DOWN
MY BUTTON
KEYSTONE MUTE