Jenn-Air D156 Use And Care Manual page 39

Other Hints on
Caring for Your Range
Oven Light Bulb
Before replacing bulb, disconnect power to oven at the main fuse or circuit breaker
panel. Be sure that the entire oven cavity including the light bulb is cool before
attempting to remove.
To replace light bulb:
1. Carefully remove the glass light lens and lens
retainer by removing the two screws in the light
lens retainer using a phillips screwdriver. Note: The
light lens is separate from the light lens retainer.
The two pieces will drop down into your hands at
the same time. Do NOT remove the remaining two
screws.
2. To obtain firm grasp on bulb, wear protective
rubber gloves. Remove by turning bulb to the left.
Do not touch a hot oven light bulb with a damp
cloth as bulb will break. Note: If the bulb does
break and you wish to remove it, be certain power
supply is disconnected and wear protective gloves.
You_may contact your authorized Jenn-Air Service
Contractor for service.
3. Replace bulb with a 40 watt oven-rated appliance
bulb. Bulb with brass base is recommended to
prevent fusing of bulb into socket. "
4. Place light lens inside of light lens retainer. Hold-
ing the light lens and lens retainer in place, insert /
the two screws into the light lens retainer and
tighten.
Access Door (Model S176 only)
The access door is easily removed to clean under the
range if necessary. To remove door, pull door down
and lift off pivot points. To replace door, slide door
over pivot points; lift up and insert prongs into holes in
the range.
To avoid the possibility of accidentally disconnecting
any part of the ventilation system, do not use the area
behind the access door for storage
i i! i
41