Troubleshooting; Event Messages - SMA Sunny Boy 3000TL-US Installation Manual

SMA America, LLC

11 Troubleshooting

11.1 Event Messages

Display message
AFCI self-test successful
Backup mode on
Grid guard code valid
No new update SDcard
Grid param.unchanged
Parameters set successfully
SD card is read
Self-test
Set parameter
Standalone op.
Update completed
Update main CPU
Update communication
Update RS485I module
Update Speedwire
Upd. language table
Update Webconnect
Update Zigbee
Update file OK
Installation Manual
Cause
The inverter has successfully performed the arc fault detection
self-test.
The inverter is operating in grid parallel operation with adjusted
grid monitoring.
The SMA Grid Guard code entered is valid. Protected parameters
have now been unblocked and you can adjust the parameters.
The parameters will be automatically locked again after
10 feed-in hours.
There are no update files relevant for this inverter on the SD card
or the available update has already been carried out.
The selected rotary switch position is not assigned or it is not
possible to change the grid parameters.
A new country data set has been configured.
The inverter is currently reading the SD card.
The self-test is being carried out.
The inverter is setting the parameters.
The inverter is operating in the secure power supply operation.
The inverter has successfully completed the update.
The inverter is performing an update of the inverter components.
The inverter is performing an update of the communications
components.
The inverter is updating the RS485i module.
The inverter is updating the Speedwire module.
The inverter is updating the language table.
The inverter is updating the Webconnect module.
The inverter is performing an update of the ZigBee
in the inverter.
The update file found is valid.
11 Troubleshooting
®
components
SB3-5TLUS22-IA-en-12 59