SMA America, LLC
Rotary switch A
position
D
D
D
D
D
E
E
E
E
E
E
E
* The country data set is automatically blocked after ten feed-in hours. Then you can only change the country data set by
entering the personal access code you received from SMA on a communication device.
7.1.2 Changing the Country Data Set and the Display Language
If the default country data set of the inverter does not apply to your country, you must change the
country data set and the display language.
1. If the inverter is in operation, disconnect it (see Section 10).
2. Set the rotary switches A and B to the desired
position using a flat-blade screwdriver
(blade width: 2.5 mm) (see Section 7.1.1
"Overview of the Rotary Switches", page 47).
3. Commission the inverter (see Section 7.2).
☑ The inverter will adopt the setting after commissioning. This can take up to 5 minutes.
Installation Manual
Rotary switch B
position
2
3
4
5
6
0
1
2
3
4
5
6
Country data set
Island mode 60 Hz
Island mode 60 Hz
Island mode 60 Hz
Island mode 60 Hz
Island mode 60 Hz
Island mode 50 Hz
Island mode 50 Hz
Island mode 50 Hz
Island mode 50 Hz
Island mode 50 Hz
Island mode 50 Hz
Island mode 50 Hz
SB3-5TLUS22-IA-en-12
7 Commissioning
Display language
French
Spanish
Italian
Greek
Czech
English
German
French
Spanish
Italian
Greek
Czech
49