Dual Cable Scale Configuration Bar Codes; Scale Protocols - Metrologic Stratos MS2x20 Series Configuration Addendum

S C
CALE ONFIGURATION

Dual Cable Scale Configuration Bar Codes

Scale Protocols

The following bar codes will change scale parameters intended for a
Dual Cable environment. To place the scanner in Dual Cable mode,
please refer to page 24.
If the MS2xx0 is currently in a Dual Cable configuration, temporarily
disconnect the Scale to Host cable prior to configuring the scale.
The MS2xx0 does not need to be in scale service mode.
The Scale Save Data bar code must be scanned last to save the
changed configuration (see page 2).
Scale = EPOS Protocol
³ 9 9
Scale = EPOS2 Protocol
³ 9 9
B
AR
6 0 1 3
6 0 1 4
C
ODES
Set the scale RS232 protocol to
Serial EPOS.
Communication Port Settings:
•
2400 Baud
•
7 Data Bits
•
1 Stop Bit
•
Even Parity
Set the scale RS232 protocol to
Modified Serial EPOS.
This Protocol does not require the POS
terminal to send the weight back to the scale
for validation.
Communication Port Settings:
•
2400 Baud
•
7 Data Bits
•
1 Stop Bit
•
Even Parity
12