Bowers & Wilkins SA250 Mk2 Custom Installation page 5

3. Installation
The SA250 Mk2 subwoofer amplifier is intended to be
installed in a standard 19-inch equipment rack. It is supplied
with rack-mount brackets, but not rack mount bolts and
nuts. Ensure that, once mounted in the rack, the amplifier
is well ventilated and that its ventilation apertures are not
obstructed. If the system is taken out of use for a long period,
disconnect the subwoofer amplifier from the mains power
supply.
Rack Mounting
The SA250 Mk2 is supplied with two rack mounting brackets
for installation in standard equipment racks (above). Attach
the brackets by inserting three of the short Philips head
machine screws through each bracket into the threaded
holes in the side of the amplifier.
x 6
Rack Handles
Use of the handles is optional. Attach them by inserting two
long Phillips head screws through each bracket into the
threaded holes in the handles (above). If you do not use the
handles, block the exposed holes in the brackets with the
rubber plugs supplied.
x 4
5