Adjust (Adjustment) - Canon 1000 Service Manual

C. ADJUST (adjustment)
DISP COUNTER
ADJUST
FUNC
OPTION
TEST
1 ADJ-XY
2 DOC-REC
3 PROJ (Note 1)
4 ED/RF
5 V-CONT
6 COL-ADJ
7 PASCAL
8 ADJ-MISC
9 FEED-ADJ
10 REG-OFS
11 ENV-SET
12 HV-TR Y/M/C/K
13 HV-SP
14 HV-FS
15 HV-EL
16 DTMP-ADJ
Note 1:
Only if connected the projector
COPYRIGHT © 2001 CANON INC.
<M> <S>
ADJ-XY
V-CONT
FEED-ADJ
HV-TRY
HV-SP
Adjusts the image start position.
Adjusts the original detection area/slide level.
Adjusts the projector area.
Adjusts the editor.
Adjusts the photosensitive drum surface potential contrast.
Corrects the color balance (for user).
Determines whether to use or not data obtained by auto gradation correc-
tion control and display of data related to auto gradation correction control.
ADJ-MNISC (adjustments other than above)
Adjusts the feeding position.
For R & D
Use it to set cassette heater operation conditions.
Fine-adjusts transfer high-voltage output by condition.
Fine-adjusts separation high-voltage output by condition.
Use it to make fine-adjustments for the pre-fixing high-voltage output
according to conditions.
Use it to make fine-adjustments for the internal static eliminator high-
voltage output according to conditions.
For future expansion
CANON CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
7. TROUBLESHOOTING IMAGE FAULTS/MALFUNCTIONS
<R> <P>
DOC-REC PROJ
COL-ADJ PASCAL
REG-OFS
HV-TRM HV-TRC
HV-FS HV-EL
<F>
ED/RF
ADJ-MISC
ENV-SET
HV-TRK
DTMP-ADJ
HV-TRK
7-225