Transfer Belt Mount; Cleaning The Transfer Belt Home Position Sensor; Removing The Transfer Cleaning Blade; When Replacing The Transfer Cleaning Blade - Canon 1000 Service Manual

3) Wipe the transfer belt seam detecting sticker
[4] attached to the back of the transfer belt with
lint-free paper moistened with alcohol two to
three times.
After work, check to make sure that the
transfer belt is not in contact with the end
sensor belt.
10mm
[4]
Figure 4-440A
4) Execute 'FUNC > F-MISCP > E075-RLS' in
service mode to initialize the transfer belt
swing data. (See chapter 7. Initializing the
Transfer Belt Swing Control Data.)
13. Cleaning the Transfer Belt Home
Position Sensor
1) Remove the transfer belt.
2) Dry wipe the light-emitting and -receiving
faces of the transfer belt home position sensor
[1] with lint-free paper.
[1]
Figure 4-441A
3) After installing the belt, execute 'FUNC > F-
MISCp > E075-RLS' in service mode to
initialize the transfer belt swing data.
COPYRIGHT © 2001 CANON INC.
45mm
CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
4. MECHANICAL SYSTEM
B. Transfer Belt Mount
1. Removing the Transfer Cleaning
Blade
1) Remove the two screws [1], and remove the
cleaning blade [2].
[2]
Figure 4-401B
2. When Replacing the Transfer
Cleaning Blade
1) Remove the transfer cleaning blade.
2) Wrap lint-free paper moistened with lubricant
arounf a finger, and lightly rub it along the
edge three times in the direction of the arrow
(same direction).
1. When rubbing the lint-free paper,
make sure that the same area of
the lint-free paper is in contact
with the blade for all three
strokes.
2. Do not force the lint-free paper
along the edge.
Figure 4-402B
[1]
4-53