Table of Contents
Advertisement
2. Why can't I connect the router even if the cable is plugged in LAN port and the LED is light?
A: First, please check Status LED. If the device is normal, the LED will blink once per second.
If not, please check the blinking Status LED as shown:
Status LED stays constantly on or off:
The system is frozen. Suggest powering off and on the router. If this symptom continues to occur,
please reset to default settings or upgrade to the latest firmware and try again.
Status LED flashes irregularly: There is an error in the system. Please reset to default settings
and reboot the router.
3. How to reset to factory default?
A: You can Restore the device by pressing "Wireless on/off" and "WPS" button.
Please make sure the ADSL router is power on and ready to use. Press the Wireless on/off button
and WPS button simultaneously, keep the buttons pressed until 5 seconds, and then release. If
the Status LED flashes about 5 times, the RESTORE process is completed.
4. When I connect to internet, some applications do not run properly when using the Wireless
ADSL router.
A: The Wireless ADSL Router processes the data passing through it, so it is not transparent.
For incoming connections, you must use the Virtual Server or Firewall Rules to specify the PC
which will receive the incoming traffic.
You can also use the DMZ function. This should work with almost every application, but:
• It is a security risk, since the firewall is disabled.
• Only one PC can use this feature.
5. When I use Static IP Address to connect to the Internet, I can access or ping global IP
addresses such as 202.93.91.218. However, I cannot access the website by using its
domain name, for example
A: Please check the DNS configuration of Static IP Address. Please refer to the information of ISP
and assign one or two DNS servers.
http://espn.com
?
72
Advertisement
Table of Contents
