Table of Contents
Advertisement
E. PPP Over ATM
1. LAN IP Address: The local IP address of this device. The computer on your network must use the LAN IP
address of this device as their Default Gateway. You can change it if necessary.
2. PPPoA Account , Password, Primary and Secondary DNS: Enter the proper settings provided by your ISP.
3. Maximum Idle Time: the time of no activity to disconnect your PPPoA session. Set it to zero or enable "Auto-
reconnect" to disable this feature. If Auto-reconnect is enabled, this device will connect with ISP automatically
after system is restarted or connection is dropped.
4. Connection Control: There are 3 modes to select:
Connect-on-demand: The device will link up with ISP when the clients send outgoing packets.
Auto Reconnect (Always-on): The device will link with ISP until the connection is established.
Manually: The device will not make the link until someone clicks the connect-button in the Status-page.
5. Service Name: Sometimes your ISP would give you a specified service name to dial-up.
6. Assigned IP Address: If your ISP provides you a specified IP address, fill it here.
7. Maximum Transmission Unit (MTU): Most ISP offers MTU value to users. The default MTU value is 0 (auto).
8. IGMP: If you enable this option, the device would allow IGMP packet pass through.
9. Data Encapsulation: Vc-MUX and LLC, these two options depend on your ISP setting.
10. VPI and VCI, Schedule Type: these values depend on your ISP setting.
24
Advertisement
Table of Contents
