Table of Contents
Advertisement
F. PPP Over Ethernet
1. PPPoE Account and Password: The account and password your ISP assigned to you. For security, this field
appears blank. If you don't want to change the password, leave it blank.
2. Primary and Secondary DNS: Enter the proper settings provided by your ISP.
3. Maximum Idle Time: the amount of time of inactivity before disconnecting your PPPoE session. Set it to zero or
enable "Auto-reconnect" to disable this feature.
4. Connection Control: There are 3 modes to select:
Connect-on-demand: The device will link up with ISP when the clients send outgoing packets.
Auto Reconnect (Always-on): The device will link with ISP until the connection is established.
Manually: The device will not make the link until someone clicks the connect-button in the Status-page.
5. Service Name: Optional. Input the service name if your ISP requires it. Otherwise, leave it blank.
6. Assigned IP Address: It is required by some ISPs. (Optional)
7. Maximum Transmission Unit (MTU): Most ISP offers MTU value to users. The default MTU value is 0 (auto).
8. IGMP: If you enable this option, the device would allow IGMP packet pass through.
9. Data Encapsulation: Vc-MUX and LLC, these two options depend on your ISP setting.
10. VPI and VCI, Schedule Type: these values depend on your ISP setting.
Afterwards, click on "Save" to store your settings or click "Undo" to give up the changes.
25
Advertisement
Table of Contents
