Table of Contents
Advertisement
Using Dolby Enabled Speakers
g
h
i
k
g h Dolby Enabled Speaker (Front)
i j Dolby Enabled Speaker (Surround)
k l Dolby Enabled Speaker (Back)
A Dolby Enabled Speaker is specially designed to be used
as a Height speaker. There are two types of Dolby Enabled
Speakers; types placed on top of other speakers such as
front speakers and surround speakers ( Ú ), and types that
are integrated with the normal speakers. Dolby Enabled
Speakers placed with their diaphragms facing toward the
ceiling create higher effect in the Dolby Atmos and Dolby
Surround listening modes by providing sounds echoing
off the ceiling. You can select gh, ij, or kl on this
unit. For connection with the unit, use the HEIGHT speaker
terminals.
＊ You can put kl on top of back speakers, but even if you connect both
back speakers and kl speakers at the same time, you can only output
audio from one of these at a time.
En-8
When playing Dolby Atmos, the speakers required depend
on how you have setup your back speakers or height
speakers. The following shows speaker combinations.
Connection
pattern
1
Back
2
Front High
3
Rear High
4
Top Front
5
Top Middle
j
6
Top Rear
7
Dolby Enabled Speaker (Front)
8
Dolby Enabled Speaker (Surround)
l
9
Dolby Enabled Speaker (Back)
Required Optional Ú Connection of a subwoofer is optional.
Instructions on how to connect speakers
Cut and remove the plastic coating from the end of the
speaker cable, twist the core and connect it to the terminal.
Make correct connection between the unit's jacks and
speaker's jacks (+ to + and - to -) for each channel. If
connection is wrong, a bass sound may become poor due
to reverse phase. Up to two subwoofers with built-in power
amplifier can be connected to the SUBWOOFER jacks.
Set the cut-off filter selection switch of the subwoofer to
DIRECT. If the subwoofer does not have a cut-off filter
selection switch but has a cut-off frequency adjusting dial,
turn it to the maximum frequency. If your subwoofer does
not have built-in power amplifier, you can connect a power
amplifier between the unit and the subwoofer.
･ Short-circuiting the + cable and - cable or contacting
the cable core to the rear panel of the unit may cause
failure. Also do not connect two or more cables to one
speaker terminal or one speaker to several terminals.
Back or Height
Step 1: Connections
When using commercially available banana plugs:
tighten the speaker terminals to the end and then insert
the banana plugs. Do not insert the core of speaker cable
directly into the hole for banana plug of speaker terminal.
(North American model)
Hide quick links:
Advertisement
Table of Contents
