Onkyo TX-RZ900 Basic Manual page 15

Push Button: Use the automatic setting button of the
access point to establish connection.
Select "Push Button" with the cursor buttons and press
1
ENTER.
Hold down the automatic setting button of the access
2
point for the necessary seconds, select "OK" with the
cursor buttons and press ENTER.
PIN code: Select this method when the automatic setting
button of the access point is beyond the reach. Select "PIN
code" with the cursor buttons and press ENTER to display
the 8-digit PIN code. Register the displayed PIN code to
the access point, select "OK" with the cursor buttons and
press ENTER. For how to register the PIN code to the
access point, refer to its instruction manual.
4. Select "Yes, Start to Check" in the network
connection confirmation screen.
When the access point is not displayed
Select "Other..." with the c cursor on the remote
controller and press ENTER to display the keyboard
screen. Input the SSID and password. Make the
following settings according to the router setting.
■ WPA/WPA2 method
Select "WPA" or "WPA2" in "Security Method", and
press ENTER.
■ WEP method
Select "WEP" in "Security Method" and select
"Default Key ID", and press ENTER.
･ If encryption setting has not been made on the
wireless LAN router, select "None" in "Security
Method", and press ENTER.
■ When "Use iOS Device (iOS7 or later) is
selected
2. On the iOS device, go to "Settings"-"Wi-Fi" and turn
on the setting, then select this unit in "SETUP NEW
AIRPLAY SPEAKER".
3. Tap "Next".
4. Select "Yes, Start to Check" in the network
connection confirmation screen.
＊ Privacy policy
A confirmation screen asking you to agree to the privacy
policy is displayed during network setting. Select "Yes" and
press ENTER to indicate agreement.
ONKYO PRIVACY STATEMENT
To improve our products and services of Onkyo Corporation,
Onkyo may collect information about your receiver usage.
To know more about what type of information we collect and
how we use it please review Onkyo's Privacy Policy at
http://www.onkyo.com/privacy/
I have read Onkyo's Privacy Policy and agree to its terms.
Yes
No
■ If connection is successful
"Successfully Connected" is displayed on the screen.
Network Connection
MAC Address xxxxxxxxxxx
IP Address, Subnet Mask, Gateway, DNS Server
Gateway Ping
Internet Service Test
Successfully connected.
Next
If this is not displayed, try doing the setting again. If "Push
Button" connection with the wireless LAN router does not
work, try "Enter Password".
■ Terminating initial setup
After finishing the initial setup, keep "Finished" selected
and press ENTER on the remote controller. Connection and
setting of the unit is now complete.
Audio output of connected players
To enjoy digital surround sound including Dolby
Digital and DTS, audio output should be set to
"Bitstream output" on the connected Blu-ray Disc
Player or other device. Depending on the settings
on the Blu-ray Disc Player there may be cases when
Dolby TrueHD, Dolby Atmos, and DTS-HD Master
Audio audio is not output according to the format of
the source. In this case, in the Blu-ray Disc Player
settings try setting "BD video supplementary sound"
(or secondary sound) to "Off". Change the listening
mode after changing the setting to confirm.
SETUP Exit
Step 2: Initial Setup
En-15