XG-PH70X/XG-PH70X-N (1st. Edition)
[14] Removing the Power Unit and Audio Unit
1. Remove the four screws from the power unit.
2. Detach the power air guide from the power channel upper.
3. Remove the four screws from the power channel down and then disconnect the two power connector PR.
4. Remove the four screws from the power unit and then take out the power unit.
5. Remove the four screws from the holders and then disconnect the signal connectors SG.
6. Remove the four screws from the audio unit and then take out the audio unit.
14-1
Power Unit
Power Channel upper
SG
Audio Unit
14-2
Power Air Guide
14-6
Ballast Unit
Holder
14-4
Holder
Power Unit
14-5
Power Unit Insulator
Power Channel Down
14-3
Chassis
2 – 12