Removing And Installing The Lamp Unit - Sharp XG-PH70X Service Manual

XG-PH70X/XG-PH70X-N (1st. Edition)
Removing and Installing
the Lamp Unit
Info
Ensure the lamp unit is removed using the
handle. Ensure the glass surface of the
lamp unit or the inside of the projector are
not touched.
To avoid injury to yourself and damage to
the lamp, make sure you carefully follow
the steps below.
Do not loosen other screws except for the
lamp unit cover and lamp unit.
(Only the silver screws are loosened.)
1
Press
on the remote control to put
the projector into standby mode.
Wait until the cooling fan stops.
Warning!
Do not remove the lamp unit from the
projector right after use. The lamp and
parts around the lamp will be very hot
and may cause burn or injury.
2
Disconnect the power cord.
Unplug the power cord from the AC
socket.
Leave the lamp until it has fully cooled
down (about 1 hour).
3
Remove the lamp unit cover.
Loosen the user service screw (
secures the lamp unit cover. Remove the
lamp unit cover (
on the projector or
) that
1
).
2
Optional
accessories
STANDBY button
2
1
1 – 13
Lamp unit 1
AN-PH7LP1
Lamp unit 2
AN-PH7LP2
User service screw