Honeywell MX8 Reference Manual page 256

Parameter Default
BG: On-Start
RX
on Main
Diversity
A: Main Only
The options for the RX Diversity parameter should be set, based on the antenna configuration, as follows:
Antenna Configuration
A Main and BG Main
A Main and A Aux
BG Main and BG Aux
Contact Technical Assistance
Parameter Default
Frag
2346
Thresh
RTS
2347
Thresh
LED Off
Tray Icon On
Hide
On
Password
SUMMIT
Admin
(or
Password
Blank)
Auth 8
Timeout seconds
7-20
How to handle antenna diversity when receiving packets from the Access Point.
Options are: Main Only (use the main antenna only), Aux Only (use the auxiliary antenna
only), On-start on Main (on startup, use the main antenna), or On-start on Aux (on startup, use
the auxiliary antenna).
RX Diversity
Main Only
On-start on Main
On-start on Main
if you have questions about the antenna(s) installed on your MX8.
If the packet size (in bytes) exceeds the specified number of bytes set in the fragment threshold, the
packet is fragmented (sent as several pieces instead of as one block). Use a low setting in areas
where communication is poor or where there is a great deal of wireless interference.
Options are: Any number between 256 bytes and 2346 bytes.
If the packet size exceeds the specified number of bytes set in the Request to Send (RTS) threshold,
an RTS is sent before sending the packet. A low RTS threshold setting can be useful in areas where
many client devices are associating with the Access Point.
Options are: Any number between 0 and 2347.
The LED on the wireless card is not visible to the user when the wireless card is installed in a sealed
mobile device.
Options are: On, Off.
Determines if the Summit icon is displayed in the System tray.
Options are: On, Off
When On, the Summit Config Utility masks passwords (characters on the screen are displayed as an
*) as they are typed and when they are viewed. When Off, password characters are not masked.
Options are: On, Off.
A string of up to 64 alphanumeric characters that must be entered when the Admin Login button is
tapped. If Hide Password is On, the password is masked when typed in the Admin Password Entry
dialog box. The password is case sensitive. This value is masked when the Admin is logged out.
Options are: none.
Specifies the number of seconds the Summit software waits for an EAP authentication request to
succeed or fail.
If the authentication credentials are stored in the active profile and the authentication times out, the
association fails. No error message or prompting for corrected credentials is displayed.
If the authentication credentials are not stored in the active profile and the authentication times out,
the user is again prompted to enter the credentials.
Options are: An integer from 3 to 60.
Function
Function