Honeywell MX8 Reference Manual page 104

Message
Taskbar hook failure AppLock is unable to control the taskbar to prevent the locked application from re-enabling it.
Taskbar hook OK AppLock successfully installed control of the taskbar.
Timeout looking for app After the application is launched, AppLock must wait until the application has initialized itself before proceeding.
window The application did not start successfully and AppLock has timed out.
ToUser after admin, not at The user mode switch is attempted when the device boots and after the administrator presses the hotkey. The
boot mode switch is being attempted after a hotkey press.
ToUser after admin-app The switch to user mode is being made via a hotkey press and the administrator has left the application open
still open and has not made any changes in the configuration.
If user mode is being entered via a hotkey press, the administrator may have left the configured application
ToUser after admin-no
open. If so, AppLock does not launch the application again unless a new application or command line has been
app or cmd line change
specified; otherwise, it just locks it.
The desktop is moved when switching into user mode. This prevents them from being visible if the application is
Unable to move desktop
exited and restarted by the timer. This error does not affect the screen mode switch; processing continues.
The taskbar is moved when switching into user mode. This prevents them from being visible if the application is
Unable to move taskbar
exited and restarted by the timer. This error does not affect the screen mode switch; processing continues.
Unhook taskbar wndproc
AppLock could not remove its control of the taskbar. This error does not affect AppLock processing
failure
Unhook wndproc failure AppLock could not remove the hook that allows monitoring of the application.
In administration mode, the taskbar should return to normal operation, so AppLock's control of the taskbar
Unhooking taskbar
should be removed.
When the administrator leaves user mode, the device is fully operational; therefore, AppLock must stop
Unhooking wndproc
monitoring the locked application.
WM_SIZE adjusted This message denotes that AppLock has readjusted the window size.
X after Ctrl+L Processing the backdoor entry.
Ret from password <#> Return value from password dialog.
Decrypt data len <#> Length of decrypted password.
Window handle to The window handle that is passed to the enumeration function. This message can be used by engineering with
enumwindows=%x other development tools to trouble shoot application lock failures.
WM_WINDOWPOSCHG
Output the window size after it has been adjusted by AppLock
adjusted=%x
4-66
Explanation and/or corrective action Level
LOG_ERROR
LOG_EX
LOG_ERROR
LOG_EX
LOG_EX
LOG_EX
LOG_ERROR
LOG_ERROR
LOG_ERROR
LOG_ERROR
LOG_EX
LOG_EX
LOG_EX
LOG_EX
LOG_EX
LOG_EX
LOG_EX
LOG_EX