Honeywell MX8 Reference Manual page 102

Message
Getting encrypt pwd
The length of the encrypted password is being calculated.
length
AppLock is unable to lock the application. This could happen if the application being locked encountered an
Hook wndproc failure
error after performing its initialization and shut itself down prior to being locked by AppLock.
Hook wndproc of open
The application is open, but AppLock cannot lock it.
app failure
Hot key event creation
The Admin applet is unable to create the hotkey notification.
failure
Hot key pressed Processing the hotkey and backdoor entry
Hot key pressed Processing the hotkey and backdoor entry
When the administrator changes the hotkey configuration the hotkey controller must be notified. This
Hot key set event failure
notification failed.
Hotkey press message
The user just pressed the configured hotkey.
received
In addition to preventing the locked application from exiting, AppLock must also prevent the application from
In app hook:WM_SIZE enabling the taskbar and resizing the application's window. This message traps a change in the window size
and corrects it.
In app hook:WM_ In addition to preventing the locked application from exiting, AppLock must also prevent the application from
WINDOWPOSCHANGED enabling the taskbar and resizing the application's window. This message traps a change in the window
position and corrects it.
Initializing keyboard hook
AppLock is calling the keyboard hook initialization.
procedure
Keyboard hook
The keyboard filter initialization failed.
initialization failure
Keyboard hook loaded OK
The keyboard hook dll exists and loaded successfully.
L after Ctrl Processing the backdoor entry.
When AppLock first loads, it loads a dll that contains the keyboard hook processing. This message is logged
Loading keyboard hook
prior to the load attempt.
The status information is being saved to a file and the file open has failed. This could occur if the file is write
Open failure
protected. If the file does not exist, it is created.
If the Administration registry key does not exist, the switch to user mode fails because the AppName value in
Open registry failure
the Administration key is not available.
Opened status file The status information is being saved to a file and the file has been opened successfully.
Out of memory for
Not enough memory to encrypt the password.
encrypted pwd
pRealTaskbarWndProc
The taskbar control has already been installed.
already set
Pwd cancelled or invalid- The password prompt was cancelled by the user or the maximum number of failed attempts to enter a
remain in user mode password was exceeded.
Read registry error-hot The hotkey registry entry is missing or empty. This is not considered an error. The keyboard hook uses an
key embedded default if the value is not set in the registry.
Read registry failure-app
AppName registry value does not exist or is empty. This constitutes a failure for switching into user mode.
name
4-64
Explanation and/or corrective action Level
LOG_EX
LOG_ERROR
LOG_ERROR
LOG_ERROR
LOG_EX
LOG_EX
LOG_ERROR
LOG_
PROCESSING
LOG_EX
LOG_EX
LOG_
PROCESSING
LOG_ERROR
LOG_EX
LOG_EX
LOG_
PROCESSING
LOG_ERROR
LOG_ERROR
LOG_EX
LOG_ERROR
LOG_EX
LOG_EX
LOG_ERROR
LOG_ERROR