Zenith H-100 Service Manual page 63

10-82
INTRODUCTION
The procedures on the following pages show you how to remove
the H-207 Floppy Disk Controller Board from the two
different models of the H/Z-100. Find the appropriate
procedure and follow the instructions.
ALL-IN-ONE
With a flat-blade screwdriver, slide the
latch bracket to the center of the slot
in the cabinet top. The latch bracket
is spring loaded, so you will have to
work with one side of the cabinet top
at a time. While holding the latch in
the center position, lift that side of
the cabinet top. After one side is freed,
perform the procedure on the other side.
Be sure to hold the freed side up, so
it will not snap back down.
Remove the cabinet top and set it aside
in a safe place.
5-147