Setting The Spool Of Thread; Additional Spool Pin; Winding The Bobbin; Removing The Bobbin - Janome memory craft 15000 Instruction Manual

Janome 15000 Instruction Manual
e
z
x
www.toews.com

Setting the Spool of Thread

Open the top cover.
Lift up the spool pin. Place the spool of thread on the
spool pin.
Attach the large spool holder, and press it rmly against
the spool of thread.
If you use a slippery thread such as monolament
transparent thread, put the net on the spool of thread
to prevent the thread from slipping off the spool and
jamming around the spool pin.

Additional spool pin

Use the additional spool pin when you need to wind a
bobbin without unthreading the machine while working on
a sewing project (refer to page 109).
Set the spool stand q under the additional spool pin w.
Insert the additional spool pin w into the hole e.
r Place the felt r and a spool on the pin.
w
q

Winding the Bobbin

Removing the bobbin

w
q
z Slide the hook cover release button q to the right,
x Remove the bobbin from the bobbin holder.
12
NOTE:
Use the small spool holder to hold narrow or small
spools of thread.
q Spool stand
w Additional spool pin
e Hole for additional spool pin
r Felt
NOTE:
The additional spool pin is also used for twin needle
sewing.
CAUTION:
Press the lockout key or turn the power switch off.
and remove the hook cover plate w.
q Hook cover release button
w Hook cover plate
NOTE:
Use the plastic bobbins for horizontal hook marked
with a "J". Using other bobbins, such as pre-wound
paper bobbins, may cause stitching problems and/
or damage to the bobbin holder.
Janome Memory Craft 15000
MC15000 Owners Manual/ User Guide