Epson WF R8591 User Manual page 168

User's Guide
Code Problem
325 There is not enough storage space available in the
specified folder.
327 The memory is full.
328 The destination was wrong or the destination does
not exist.
331 A communication error occurred while acquiring the
destination list.
332 There is not enough storage space available to save
the scanned image in the destination storage.
333 The destination could not be found because the
destination information was uploaded to the server
before sending the scanned image.
334 An error occurred while sending the scanned image.
341 A communication error has occurred.
401 There is not enough storage space available to save
the data in the memory device.
402 The memory device is write-protected.
404 The memory device has been removed.
405 An error occurred while saving the data to the
memory device.
411 A DNS error has occurred.
412 An authentication error has occurred.
Solving Problems
Solution
❏ Increase the storage space in the specified folder.
❏ Reduce the number of documents.
❏ Lower the scanning resolution or increase the
compression ratio to reduce the size of the
scanned image.
Wait until other ongoing jobs are finished.
Check the Location settings.
Check the network connection. See the Network
Guide for more details.
Reduce the number of documents.
Select the destination again.
-
❏ Check the connections for the printer and the
computer. If you are connecting over a network,
see the Network Guide.
❏ Make sure that Document Capture Pro is installed
on the computer.
Increase the storage space in the memory device.
Disable write protection on the memory device.
Reinsert the memory device.
❏ Reinsert the memory device.
❏ Use a different memory device on which you have
created a folder using the Create Folder to Save
function.
❏ Select Setup > System Administration > Wi-Fi/
Network Settings > Advanced Setup > DNS
Server, and then check the DNS settings.
❏ Check the DNS settings for the server, the
computer, or the access point.
Select Setup > System Administration > Wi-Fi/
Network Settings > Advanced Setup > Email
Server > Server Settings, and then check the server
settings.
168