Epson WF R8591 User Manual page 166

User's Guide
Code Problem
111 Available memory is running low.
201 The memory is full.
202 The line was disconnected by the recipient machine.
203 The product cannot detect the dial tone.
204 The recipient machine is busy.
205 The recipient machine does not answer.
206 The phone cable is incorrectly connected to the LINE
and EXT. port of the product.
207 The product is not connected to the phone line.
208 The fax could not be sent to some of the specified
recipients.
301 There is not enough storage space available to save
the data in the memory device.
302 The memory device is write-protected.
303 No folder has been created to save the scanned
image.
304 The memory device has been removed.
Solving Problems
Solution
Try the methods below to reduce the size of the print
job.
❏ Lower the print quality and the resolution.
❏ Change the format setting.
❏ Reduce the number of images, letters or fonts
used in the print job.
❏ Print received faxes from Job Monitor in Status
Menu.
❏ Delete received faxes saved in the inbox from Job
Storage in Status Menu.
❏ If you are sending a monochrome fax to a single
destination, you can send it by using Direct Send.
❏ Divide your originals in two or more to send them
in several batches.
Wait for a while and then try again.
❏ Make sure that the phone cable is connected
correctly and the phone line is working.
❏ When the printer is connected to the PBX or the
terminal adapter, change the Line Type setting to
PBX.
❏ Select Setup > System Administration > Fax
Settings > Basic Settings > Dial Tone
Detection, and then disable the dial tone setting.
Wait for a while and then try again.
Wait for a while and then try again.
Check the connection of the LINE port and the EXT.
port of the printer.
Connect the phone cable to the phone line.
Print a Fax Log or Last Transmission report for
previous faxes from Fax Report in the Fax mode to
check the failed destination. When the Save Failure
Data setting is enabled, you can resend a fax from
Job Monitor in Status Menu.
❏ Increase the storage space in the memory device.
❏ Reduce the number of documents.
❏ Lower the scanning resolution or increase the
compression ratio to reduce the size of the
scanned image.
Disable write protection on the memory device.
Insert another memory device.
Reinsert the memory device.
166