Ribbon Sensor Verification - SATO CL612e Service Manual

4.9 Ribbon Sensor Operation Verification
STEP
1.
2.
3.
4.
5.
6.
7.
8.
PN 9001079
Rev. B
PLACE DSW2-1 IN
THE OFF POSITION
PROCEDURE
.lip down the cover on the front panel for access to the dip switches.
Record all dip switch positions, then place DSW2-1 in the O.. position and
the power switch O...
Remove the ribbon from the printer and close the Head Open Lever.
Turn the power switch ON to initialize the printer. The following screens
will display.
initializing
rom v00.00.00.00
Press the LINE key to place the printer off-line.
Press the .EED key. The printer will beep and the following screen will
display to confirm that the ribbon is not in position and confirm the sensor is
functioning.
Ribbon end
Turn off the printer and reinstall the ribbon.
Turn ON the printer. The printer will initialize as in Step 4. Be sure to place
the printer off line. Press the .EED key to generate a blank label and
confirm ribbon has been installed and is in position.
SATO CL608e/CL612e Service Manual
Section 4. Electric Checks and Adjustments
No adjustment is provided
for this sensor
SEE PAGE 1-8 FOR
SENSOR LOCATION
online
qty:000000
Page 4-13