System Setup; System Configurations; Network Settings - Planet NVR-810 User Manual

Hide thumbs Also See for NVR-810:

Table of Contents

6. System Setup

The "System Configurations" page provides users options to setup the device quickly

and properly. After properly configuring all settings in all the sub-pages, users should

expect a fully working network video recorder that is ready to manage cameras on the

network. We will start by configuring its network settings to make sure it works

correctly in your network. Next, we will help you adjust the system time so videos will

be recorder with correct timestamp. To better secure the system for unwanted

disturbance, we will guide you on setting up user's account and privileges to prevent

settings gets altered by users other than the system administrator. Lastly, we will tell

you what you should expect after installing a hard disk and how to prepare the hard

disk for the video recording.

You need to adjust settings in this page for the device to work properly in your network.

It is critical that settings here are configured correctly based on your network

configurations so that the recorder can be administered through the local area network

and cameras can be connected from it.

By default, the recorder is set to obtain IP address from DHCP server, it should be

sufficient in most network environments, and most likely you should not need to alter

anything in this page. To locate the recorder, simply use the IP Utility with steps

described in page 13.

Table of Contents

Nvr-1610